Description PROPERTIES High initial tack (600 kg/m² in 10 seconds) High final strength (25 kg/cm² in 6 hours) For all materials Suitable for all surfaces For interior & exterior use Easy to apply Filling Solvent-free Permanently elastic Correctable Moisture resistant Temperature resistant Non-shrinking; 100 % adhesive WHAT DOES IT DO? SUITABLE FOR: All kinds of materials: e.g. wood, Trespa®, iron, aluminum, zinc, (stainless) steel, and other metals, (natural) stone, ceramic, concrete, brick, plaster, glass, PVC, ABS, PC, PMMA and other synthetic materials (test in advance), cork and polystyrene foam on all kind of surfaces (smooth, porous, non-porous and slightly moist). All kinds of objects: e.g. skirting boards, laths, window sills, tear plates, thresholds, fascia boards, plate material, insulation material, stair steps, sheeting material, floorboards, plasterboard, ceramic tiles, mirrors and polystyrene ornaments and borders. NOT SUITABLE FOR: Not suitable for PE, PP, PTFE, pure plaster and bitumen. When gluing plastics always perform an adhesion test first. Adhesion to plastics can vary depending on the type of synthetic and the quality of the plastic. GETTING STARTED BEFORE USE: Working conditions Only apply at temperatures between 5 °C and 40 °C. Surface requirements Surfaces must be clean, dust- and grease-free. Surface must be solid. The surface may be slightly moist. Use of primer not required. Tools Use putty knife or spatula to apply. If necessary, use a rubber mallet to tap lightly. For surface bonding use a glue spreader (2 mm). Preparation of product Before using open cartridge at the top by cutting off the plastic nipple above the thread with a Multi Tool. Fix the nozzle onto the cartridge and cut at an angle to the desired diameter. DURING USE: Handling of packaging Only apply with special nozzle supplied. Directions for use Cut the thread and assemble the nozzle. Depending on the weight of the material, apply the adhesive evenly in vertical strips or dots at intervals of between 10 and 40 cm. Always apply adhesive to the corners and along the edges. Mutual moving of materials (facade panels) can be accommodated through an adhesive thickness of 3 mm (use spacer blocks, or tape). Assemble materials with a pushing movement and press or knock firmly together. Correction is still possible. Close the cartridge properly immediately after use. Points of attention The following drying times are based on bonding at least one porous material and an adhesive layer of approx. 1 mm thickness. If two non-porous materials are being bonded and/or the layer of adhesive is thicker, the drying times may be substantially longer. AFTER USE: Stains/residue Remove adhesive residues immediately with ammonia. Dry adhesive residue can only be removed mechanically. Storage conditions Store dry in sealed packaging between 5 °C and 25 °C.
